Yakima Gatekeeper Tailgate Pad Review | Bike Reviews Hub

Yakima Gatekeeper Tailgate Pad back end safely conveys your bicycle and four of your companions’ bicycles to the trailhead. This pad is produced using a sturdy nylon outer material to oppose scraped spots and climate harm, while the extra-delicate felt backing ensures your truck’s paintwork.

Its snare and-circle support conclusion framework backs off of carbon bicycle outlines and painted surfaces. The board framework’s incorporated lash keeps the cushion tight and secure as far as possible up the winding mountain street to the beginning of the mountain.

Furthermore, the coordinated Hindsight hide cover opens up the view for your backup camera or peering out the back see.

Review of Yakima Gatekeeper Tailgate Bike Pad

Yakima Gatekeeper Bike Tailgate Pad Review

Perfect Use For Mountain bikes

Material Used: Nylon, Felt

Weight: 5.00 lbs.

Dimensions: Large, 53.25 x 5.25 x 17.25 inches

Warranty: 2 years

Let’s look at some specs and review Yakima- Gatekeeper Tailgate Pad.

Yakima’s Gatekeeper is a Ute back-end-based bicycle stockpiling framework that goes far to taking care of those issues.

This rear-end cushion offers a secure capacity for five MTBs in the plate of your Ute, permitting you to, in any case, push a major hard case and an ice chest/cooler up the back for you and your mates’ stuff.

Furthermore, the allure of these tailgate pads is that they hold the bicycles down low (not on the rooftop rack) and permit you to fit five easily, with the accurate stacking measure super-straightforward.

Far and away superior, you don’t need to take the wheel off your bicycles to do as such, which is consistently welcome.

The Gatekeeper’s outside uses an intense nylon material, with a lot of cushioning inside, and it weighs just 3.2kg and measures 1346mm long, 432mm tall, and 127mm thick.

The most common way of fitting the Gatekeeper is straightforward and requires around five minutes; you wrap the cushion over the back end (with the long side on the external) and feed the three lashes through the hole between the open rear end and the plate.

Then, at that point, snap the tie tight through the more oversized than average clasps, and it isn’t moving.

Just as the intense nylon external, the underside of the cushion that comes in direct contact with the Ute incorporates felt backing (there’s a stable fold at the back, which gives simple admittance to your Ute plate handle, or it tends to be dropped down to cover it).

The trickiest piece of the introduction is guaranteeing the bicycle supports are lined up with the point of your bicycle’s down tube, so some portion of the bike is ensured, which isn’t in every case simple as the cylinder points on bicycles can contrast.

The downtube (and the rear end under) can cop the most discipline when bicycles are stacked without a cushion, attributable to tub/bicycle front/rearward and side-to-side development.

If there are any coarseness/dust or different materials between the down tube’s underside and the rear end lip, both cop a decent scratching/sanding, and there’s high potential for paint evacuation.

We’d suggest adding some locking framework; however, the bicycles are not rugged to fit the Gatekeeper; they’re similarly as simple to eliminate. A virtual link lock strung through the bikes will deal with this.

Stacking a bicycle should be possible by one individual by basically lifting the bike over the rear end and laying the downtube on the bicycle support, with the front wheel/gives up hanging the side.

Then, at that point, close over the Sit-Tight pad supports by circling the cushioned tie (it’s softened on the two sides) through the clasp and back finished before shutting the Velcro conclusion. Likewise, with the rear-end cushion itself, your bicycle isn’t moving when the conclusion is clamped tight.

Yakima Gatekeeper Tailgate Bike Pad

Final Words About Yakima Gatekeeper Tailgate Pad

We tried the Gatekeeper with two and three bicycles on board, and they fit serenely. The unit’s five-bicycle most outstanding limit is certainly do-capable. However, it’s a far nearer fit between bikes, with that load of forks and wheels across the back.

It would merit checking each contact point after the bicycles are gotten and including some extra cushioning if you believe it’s required.

But overall, the Yakima Gatekeeper Tailgate Pad is the perfect tailgate pad for your truck that safely conveys your bicycles to the trailhead.

Leave a Comment